IEEE 386-2016 pdf free

IEEE 386-2016 pdf free.IEEE Standard for Separable Insulated Connector Systems for Power Distribution Systems Rated 2.5 kV through 35 kV.
grounding separable insulated connector: A device that grounds and seals a dc-energized cable, cable system or apparatus. All have short-time current ratings. Those for loadbreak systems also have a fault-closure rating. Typical devices include grounding elbows, grounding bushings, and grounding caps.
NOTE—Sec Figure 21. Figure 22, Figic 23, and Fiurc 24.
grounding tab: See drain wire (grounding) tab
insulated cap: An accessory device designed to electrically insulate, electrically shield, and mechanically seal a bushing insert or integral bushing.
NOTE—Sec Figure I. Figure 21. Figure 22, Figure 23. and Figure 24.
insulated parking bushing: An accessory device designed to electrically insulate, electrically shield, and mechanically seal a power cable terminated with an elbow and to be installed into a parking stand.
NOTE—Sec Figure 21, Figure 22, and Figure 23.
insulated plug: An accessory device designed to electrically insulate, electrically shield, and mechanically seal an elbow interface.
NOTE—Sec Figure 23 and Figure 24.
integral bushing: An apparatus bushing designed for use with another connector component. such as an elbow.
NOTE—Sec Figure I. Figure 21. Figure 22, and Figure 23.
Ike break connector: A separable insulated connector designed to be separated and engaged on energized circuits under the condition of no-load. These connectors do not have a fault close rating.
loadbrcak connector: A separable insulated connector designed to close and interrupt rated load current or lesson energized circuits under specified conditions. These connectors also have a fault close rating.
malinuni sollage rating: The highest phase-to-ground voltage (rms) for single phase systems or phase-to- ground and phase-to-phase voltage (rrns) for three phase systems at which a connector is designed to operate.
multi-point separable insulated connector: A device with two or more interconnected interfaces that electrically insulate, electrically shield and seal the interfaces where the interfaces are not in an elbow, straight. nor tee configuration. Typical devices include multi-point junctions. portable feedthrus, feedthru inserts, load- break link connectors, deadbrcak link connectors, and “1-I” and “Y” disconnectable bus connectors.IEEE 386 pdf download.