BS EN 573-3:2019 pdf free
BS EN 573-3:2019 pdf free.Aluminium and aluminium alloys — Chemical composition and form of wrought products Part 3: Chemical composition and form of products.
This document specifies the chemical composition limits of wrought aluminium and wrought aluminium alloys and form of products.
NOTE The chemical composition limits of aluminium and aluminium alloys specified herein are completely identical with those registered with the Aluminium Association, 1525, Wilson Boulevard. Suite 600, Arlington, VA 22209, USA, for the corresponding alloys.
2 Normative references
The following documents are referred to in the text in such a way that some or all of their content constitutes requirements of this document. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
EN 485-2, Aluminium and aluminium alloys — Sheet, strip and plate – Part 2: Mechanical properties EN 541, Aluminium and aluminium alloys — Rolled products for cans, closures and lids — Specifications EN 546-2, Aluminium and aluminium alloys — Foil — Part 2: Mechanical properties
EN 570, Aluminium and aluminium alloys — Impact extrusion slugs obtained from wrought products — Specification
EN 573-2, Aluminium and aluminium alloys — Chemical composition and form of wrought products — Part 2: Chemical symbol based designation system
EN 586-2, Aluminium and aluminium alloys — Forgings — Part 2: Mechanical properties and additional property requirements
EN 602, Aluminium and aluminium alloys — Wrought products — Chemical corn position of semi-finished products used for the fabrication of articles for use in contact with foodstuff
EN 603-2, Aluminium and aluminium alloys — Wrought forging stock — Part 2: Mechanical properties EN 683-2, Aluminium and aluminium alloys — Finstock — Part2: Mechanical properties
EN 754-2, Aluminium and aluminium alloys — Cold drawn rod/bar and tube — Part 2: Mechanical properties
EN 755-2, Aluminium and aluminium alloys — Extruded rod/bar, tube and profiles — Part 2: Mechanical properties
3 Terms and definitions
No terms and definitions are listed in this document.
ISO and IEC maintain terminological databases for use in standardiaLeon at the following addresses:
• IEC Electropedia: available at http://wwwSelectropedia.org/
• ISO Online browsing platform: available at https://wwwiso.org/obp
4 Chemical composition limits
The chemical composition of aluminium and aluminium alloys is specified in percentage by mass in Tables 1 to 8. Limits of impurities are expressed as a maximum; limits of alloying elements shown as a range. Aluminium is specified as a minimum for unalloyed aluminium, and as a remainder for aluminium alloys.
The chemical composition of internationally registered wrought aluminium and wrought aluminium alloys not listed in this document can be found in Teal sheet.
Analysis shall be made for elements which are specified, for example Pb, Sn, Bi, Sb, Zr.BS EN 573-3 pdf free download.
