BS EN 485-2:2016 pdf free

BS EN 485-2:2016 pdf free.Aluminium and aluminium alloys – Sheet, strip and plate Part 2: Mechanical properties.
It does not apply to semi-finished rolled products in coiled form to be subjected to further rolling (reroll stock) or to special products such as corrugated, embossed, painted, sheets and strips or to special applications such as aerospace, can stock, finstock, for which mechanical properties are specified in separate European Standards.
The chemical composition limits of the alloys are specified in EN 573-3. Temper designations are defined in EN 515.
2 Normative references
The following documents, in whole or in part, are normatively referenced in this document and are indispensable for its application. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
EN 13195, Aluminium and aluminium alloys – Specifications for wrought and cast products for marine applications (shipbuilding, marine and offshore)
ASTM G66, Standard Test Method for Visual Assessment of Exfoliation Corrosion Susceptibility of Sxxx Series Aluminium Alloys (ASSET Test)
ASTM G67, Standard Test Method for Determining the Susceptibility to Intergranular Corrosion of Sxxx Series Aluminium Alloys by Mass Loss After Exposure to Nitric Acid (NAMLT Test)
3 Requirements
The mechanical properties shall be in conformity with those specified in Clause 4 or those agreed upon between supplier and purchaser and stated on the order document.
4 List of alloys with mechanical property limits
4.1 General
Table 1 to Table 54 contain mechanical property limits values obtained by tensile testing according to EN ISO 6892-1 after sampling and after sample preparation according to EN 485-1.
They also contain values of bend radius and hardness following sampling and test methods as described in EN 485-1. These values are for information only.
For some alloys they contain provisions related to inter-granular corrosion, exfoliation corrosion or stress corrosion testing, see also EN 485-1.
4.2 Elongation
The Asomm value is the elongation measured over a gauge length of 50 mm and expressed in percent.BS EN 485-2 pdf free download.