BS EN 10028-7:2016 pdf download

BS EN 10028-7:2016 pdf download.Flat products made of steels for pressure purposes Part 7: Stainless steels.
BS EN 10028-7 specifies requirements for flat products for pressure purposes made of
stainless steels, including austenitic creep resisting steels, in thicknesses as indicated in Tables 7 to 10.
The requirements of EN 10028-1 also apply.
NOTE I The steel grades covered by this European Standard have been selected from EN 10088-1.
NOTE 2 Once this European Standard is published in the Official Journal of the European Union (OJEU) under Directive 2014/68/EU, presumption of conformity to the Essential Safety Requirements (ESRs) of Directive 2014/68/EU is limited to technical data of materials in this European Standard (Part 1 and Part 7) and does not presume adequacy of the material to a specific item of equipment. Consequently, the assessment of the technical data stated in this material standard against the design requirements of this specific item of equipment to verify that the ESRs of the Pressure Equipment Directive are satisfied, needs to be done.
2 Normative references
The following documents, in whole or in part, are normatively referenced in this document and are indispensable for its application. For dated references, only the edition cited applies. For undated references, the latest edition of the referenced document (including any amendments) applies.
EN 10028-1, Flat products made of steels for pressure purposes — Part 1: General requirements
EN 10088-1:20 14, Stainless steels — Part 1: List of stainless steels
EN ISO 3651-2, Determination of resistance to intergranular corrosion of stainless steels — Part 2: Ferritic, austenitic and ferritic-austenhtic (duplex) stainless steels — Corrosion test in media containing sulfuric acid (1503651-2)
EN ISO 9444-2, Continuously hot-rolled stainless steel — Tolerances on dimensions and form — Part 2:
Wide strip and sheet/plate (ISO 9444-2)
EN ISO 9445-2, Continuously cold-rolled stainless steel — Tolerances on dimensions and form — Part 2:
Wide strip and plate/sheet (ISO 9445-2)
EN ISO 18286, Hot-rolled stainless steel plates — Tolerances on dimensions and shape (ISO 18286)
3 Terms and definitions
For the purposes of this document, the terms and definitions given in EN 10028-1 and the following apply.
3.1 cryogenic temperature temperature lower than —75 °C used In the liquefaction of gases.BS EN 10028-7 pdf download.